Clutch

Orientation

Orient the module so that the row of two knobs is at the top, with the rows of jacks located at the bottom.

Upper Controls

These controls make most sense if listed left to right. This is a 2 by 2 grid of knobs. Between the two rows, on the left you will find a horizontal SD card slot. On the right edge of the module is the BANK/HOLD FX button.

First Row

• SURFACE A
• PITCH A

Second Row

• RELEASE
• A/B BLEND

Bottom Row

The bottom row of knobs from left to right are assignable and change with the three-way toggle switch directly above them

Between these knobs, there’s a switch: CV ON/OFF.

Toggle Switches

Left switch, from left to right:

• BALANCE mixes open and closed. To the left, closed sounds will be louder, while to the right, open sounds will be louder. Keep the line at 12:00 for even mix.
• RELEASE OFFSET related to the global release knob, controls the release for the closed hat.
• HPF

Right switch, from left to right:

• SURFACE B
• SURFACE B PITCH
• LPF

Jack Rows

Row 1 (left to right)

• PITCH A (jack)
• A / B (jack)
• FEEL PTN (Momentary Switch)

Row 2 (left to right)

• SRF A
• RELEASE
• VELOCITY
• FX PRM

Row 3 (left to right)

• A (jack)
• B (jack)
• CHOKE (jack)
• OUT (jack, outlined)

Notes

• Enter effects mode by holding the bank button.
• When you are in effects mode, use the momentary switch to move through the effect types.
• Bottom knobs are used to dial in the affects.
• To adjust feel patterns, hold the momentary switch to the right and use the switch to cycle through.