Orientation
Place the module in your rack so that the knobs are at the top, and the ports are at the bottom.
Layout Overview
The panel has a symmetrical left-right design: a SOLO VOICE section on the left and a CHORD VOICE section on the right. Three rows of large knobs run across the top. A dotted center dividing line separates the two voices. Below the knobs is a row of LEDs and two labeled jack sections.
Top Knob Rows (Three Rows Across Full Width)
The panel has a center knob (TUNE or HARMONY) flanked symmetrically by matching knobs on left and right.
Row 1 (top row, left to right)
- DAMP / level (knob)
- TUNE / quantize (knob)
- DAMP / level (knob)
Row 2 (middle row, left to right)
- DECAY / glide (knob)
- HARMONY / scale (knob)
- DECAY / glide (knob)
Row 3 (lower knob row, left to right)
- ATTACK / polyphony (knob)
- (no center knob in this row)
- ATTACK / out config (knob)
buttons
Between the two knobs in row 3 are two buttons:
- TIMBRE
- ALT (right LED, green/yellow) – Indicates alternate TIMBRE mode
SOLO VOICE Section (Left Half)
Labeled “SOLO VOICE” in a grey bar across the left half.
Top jack row (left to right)
- TRIG
- ATTACK
- V/OCT
Middle jack row (left to right)
- DAMP
- DETUNE
- DECAY
Bottom jack row (left to right within solo section)
- PITCH
- MIDI
- IN
CHORD VOICE Section (Right Half)
Labeled “CHORD VOICE” in a grey bar across the right half.
Top jack row (left to right)
- V/OCT
- ATTACK
- TRIG
Middle jack row (left to right)
- DECAY
- HARMONY
- DAMP
Bottom jack row
- IN
- OUT L
- OUT R